Sulfur is a very present chemical element not only on planet Earth but in others in the universe. Here, it is found in volcanoes, hot springs, but also in underground deposits. Despite the fact that if handled unknowingly it can do a lot of damage, to the point of burning the skin, the truth is that today it is easily available in any garden store and nursery , whether physical or online. Because? Because it is a good fungicide.
And for this reason alone, it is already interesting to use it in organic farming, because fungi are microorganisms that cause a lot of damage to plants and flowers. For him, we want to explain how to add sulfur to plants.
Contents
How to apply it on plants?
Sulfur for plants is usually sold in the form of microgranules inside a plastic bag. Well, so that there are no problems, what we need to do first is put on some gardening gloves and then take a metal spoon and fill it with sulfur. Then we will spread it on the surface of the soil of the plants (never on the leaves), and around the main stem.
But yes, it is very important that we throw away little. The sulfur layer must be very thin. In this way, good results will be obtained without endangering the life of the plants. And finally, it will be watered.
Another way to present it is as liquid sulfur. The mode of application of this one is very different, since it is necessary to add a small quantity in X liters of water (the quantity will be specified on the container) and to stir before applying it on the plants using of a sprayer/atomizer.
When is the best time to apply sulfur to plants?
The best time to do it It will be spring, autumn and winter; that is to say at all times as long as it is not seen in the summer. Indeed, as we said at the beginning of the article, sulfur, just as it can burn the skin, can also burn the roots if the insolation is very high and if we have applied too much.
Indeed, in addition to applying only a thin layer, it is important to do it at the end of the afternoon, when the sun is already low. Thus, we will prevent him from suffering.
What is sulfur used for in plants?
sulfur It is a good fungicide, both preventive and curative. I strongly recommend its application in nurseries -especially of trees and palms, since these plants are very vulnerable to fungal infections during their first months of life-, as well as in any other plant that you wish to protect (for example , if we have a to which we suspect that we watered a lot when he needed it).
I also apply it on succulents and those that rot easily.as I live on an island where the air humidity is very high, sometimes it is not enough to control the irrigation well, but preventive measures must be taken so that neither excess humidity nor fungi spoil them.
Or buy?
You can get plant sulfur powder by clicking below:
And if you want it liquid, you have it here: